Designing

Okay so here is my design.

Okay so let me explain whats on the sheet. Firsty researched and found the image that inspired me, upon looking at it it reminded me of a skull, so i started researching different skull types, i done a fish, bird and human skull. in the end i attmepted the bird skull but didnt like the form and attempted the fish skull but after the line drawing moved on to the human, with each of these skulls the objective was to warp the skull shape to allow large eyes like 'flies' eyes and create a more elongated head. as you can see the design to the right, the largest design is the design i have gone with, originally it was going to be some bone anatomy of it but whilst drawing 2 bones i desided for them to be external bones over the skin. as you can see it has human teeth at the front and currently has no eyes, im not currently sure if i will incorperate eyes, i dont believe i am going to. At the bottom of the page you can see 3 body stances, this was to see how the body ould stand and the width of it. i went with the final one to the very right of the 3. i choice this one as it hangs most like a gorilla and i like how it has inverted legs whilst this stance acomidates this which is good. Above the stance test, below the main image its impossible to tell but its a tail, he will have a very small tail, this was first put here as astetics but i wanted there to be reason so i searched for reasons animals have tails, and as i assumed animals use there tails for balance so i choice to make this the reason aswell, the tail also has its own wings similar to bat wings connected from the tip of the tail back to the butt. There are also 2 other details and explaing reason and bone structure but cannot be seen on the scan, an image will be provided in a later post of them but for now i will explain them. The foor has a 'star'ish shape, This is done by having the standard foot and heal but one large toe in front and one on each other side 90 degrees from the main one, so the foot makesa cross shape, a plus with one line extended. I explained how this is for the balance once again because of its stance allowing it to also be more agile. The final small detail i explained was the hand. The hand is one large 'finger' in the shape of a claw but being tissue, muscle and bone other than the material which claws are made from, this also goes for the toes, they are not claws they have a similar shape but are also muscle and skin. i drew within the hand 2 bones which look very much like the radius and Ulna bones found in your forearm. this is because of it being one large finger i believed it needed more strenth and support then just a singular bone. the hand has 3 segments like our finger although the finger of this creature has only 2 joints. There is also 2 other possitions of the creature drawn but wasnt successful. Oh how did i forget; the head also has a pony-tail, which is pulled back tied then platted into a fish plat then tied once again at the end i thank drew for allowing me to take a photo of his pony-tail for refrence, speaking of refrence here is all the refrence used.